Brinkmann 810-8750-S - Manual (Page 17)

Retaining Nut
16
810-8550-S, 810-8552-S & 810-8555-S
ROTISSERIE BURNERS
CAUTION: Only use specified natural
gas orifice for your grill.
Note: It is helpful to keep the screws
with the components as they are
removed for ease of reassembly.
Step 10
Remove the two screws of panel to gain
access to the rotisserie LP valve on back
side of grill. Set aside for later use.
Step 11
Using an adjustable wrench to hold the
gas line secure, use the open end
wrench provided to loosen the gas line
retaining nut. With the rotisserie gas
supply line detached from the housing,
use two wrenches to remove the LP brass
orifice from the gas supply line. Replace
the LP gas brass orifice with the proper
natural gas orifice. (1.32mm YELLOW)
Note: Bending the hose could damage
the supply line.
Step 12
Reattach gas supply line to the
rotisserie housing by securing with the
retaining nut removed in Step 11.
Note: Leave the back panel off until
the end of conversion and all
gas leak testing has been
completed.
Step 13
Re-install rotisserie cover using the bolts
that were set aside in Step 10.
1.32mm
Existing Rotisserie LP
Gas Orifice
Replacement Rotisserie
Natural Gas Orifice
(identified by number)
Rotisserie Burner 1.32mm (YELLOW)
Brass Orifice
Cover Bolts