Brocade Communications Systems ServerIron ADX 12.4.00 - Manual (Page 240)

228 ServerIron ADX Global Server Load Balancing Guide
53-1002437-01
Advanced GSLB configuration for IPv6
2
• is a value from 0 to 100. The default value is 1. A weight of 0 implies that the client IP
will not be allocated any hash buckets. A weight of 0 can be used to designate a domain IP as
backup.
NOTE
The aggregate of the hash weights for all the IPs for a domain does not have to add up to 100.
When user configures a hash weight of zero for a domain IP, no hash buckets are allocated to this
domain IP. If the hash buckets for this domain does not have any other healthy IPs, then the best IP
address among all the healthy IPs including the IP with hash weight of zero, will be selected based
on the remaining GSLB metrics. So user can configure a domain IP to be used as a backup IP by
configuring a weight of zero for this IP address.
Disabling rehash on introduction of new IP addresses or state change from down
to healthy
You can disable rehash on the introduction of a new IP address or change of IP address state from
down to healthy. Persistence that occurs when rehashing is performed is prevented. The trade-off
is the new IP address will not be included in the hash table.
To disable rehash, enter commands such as the following:
SLB-ServerIronADX(config)# gslb policy
SLB-ServerIronADX(config-gslb-policy)# hash-persist persist-rehash-disable
Syntax: hash-persist persist-rehash-disable
The parameter specifies the number of seconds before an IP address is removed from
the hash table when that IP becomes down. The default is five seconds.
Disabling rehash when weight for an IP is changed
When user changes the hash weight configured for an IP in the domain, GSLB controller will
automatically rehash the hash table for that domain. You can disable this rehash on weight
configuration change with the following command.
Use the following command line interface to disable rehashing on weight change for global GSLB
policy:
ServerIronADX(config)# gslb policy
ServerIronADX(config-gslb-policy)# hash-persist disable-weight-rehash
Use the following command line interface to disable rehashing on weight change for host-level
GSLB policy:
ServerIronADX# config t
ServerIronADX(config)# gslb-host-policy test
ServerIronADX(config-gslb-host-policy-test)# hash-persist disable-weight-rehash
Syntax: [no] hash-persist disable-weight-rehash
If the weight of an IP for a domain is changed and this command is configured, then a message,
stating that the ServerIron ADX needs to be rehashed at a later time, will be displayed.