Installation location, Warning, Installation room – Bosch Single Door User Manual
Page 7: Installation cavity, Furniture/fixtures, Base
7
Installation location
1.
d
WARNING
d
Do not install the appliance:
- outdoors,
- in an environment with dripping water,
- in rooms which are at risk of frost.
Appliance is very heavy ć for empty weight see the
following table:
Refrigerator 24"
approx. 310 lbs / 140 kg
Refrigerator 30"
approx. 350 lbs / 158 kg
Freezer 18"
approx. 255 lbs / 115 kg*
Freezer 24"
approx. 300 lbs / 135 kg*
Freezer 30"
approx. 335 lbs / 150 kg*
Wine unit 18"
approx. 300 lbs / 135 kg
Wine unit 24"
approx. 360 lbs / 160 kg
(* without Water Dispenser)
Installation room
The appliance should be installed in a dry, ventilated
room.
The ambient temperature should not drop below 55 °F
(13 °C) or rise above 110 °F (43 °C), otherwise
malfunctions may occur.
The installation location should not be exposed to direct
sunlight and not placed near a heat source, such as an
oven, radiator, etc. If installation next to a heat source is
unavoidable, use a suitable insulating plate or observe
the following minimum distances from the heat source:
-
1
1
/
4
" (30 mm) from an electric cooker,
-
12" (300 mm) from an oil or solidĆfuel cooker.
Installation cavity
It is important to observe the specified dimensions of
the installation cavity for a troubleĆfree installation of the
appliance and for the subsequent general view of the
furniture front.
i
In particular ensure that the cavity is square.
Squareness can be checked by suitable means,
e.g. spirit level, diagonal measurements, etc.
i
The side walls of the cavity must be flush.
The minimum thickness of side walls and the top wall
must be
5
/
8
" (16 mm).
The minimum thickness of toe kick panel must be
1
/
2
" (13 mm).
A thickness of ¾" (19 mm) is recommended.
Furniture/fixtures
The new appliance is screwed securely to adjacent
and overhead furniture/fixtures.
For this reason it is essential that all attachable
furniture/fixtures are connected securely to the
base or the wall by suitable means.
Base
d
WARNING
d
A fullyĆload appliance is very heavy ć for the
loadĆbearing capacity at least see the following table:
Refrigerator 24"
approx. 890 lbs / 400 kg
Refrigerator 30"
approx. 1110 lbs / 500 kg
Freezer 18"
approx. 560 lbs / 250 kg*
Freezer 24"
approx. 780 lbs / 350 kg*
Freezer 30"
approx. 950 lbs / 425 kg*
Wine unit 18"
approx. 550 lbs / 245 kg
Wine unit 24"
approx. 694 lbs / 310 kg
(* without Water Dispenser)
To ensure that the appliance is installed securely and
functions properly, the base must be flat and level.
The base must be made of a hard, rigid material.
The installation area must be the same height as the rest
of the room.
On account of the heavy weight of a fully loaded
appliance, a loadĆbearing base is required. If in doubt,
contact an architect or a building expert.