BT 500 Twin - Manual (Page 27)

Press the QUICKDIAL
button.
Press the ✱ button, then the
2 button.
Press either 0 for TONE
dialling or 1 for PULSE
dialling.
Press the QUICKDIAL button
to confirm.
With some switchboards it
may be helpful to dial a
pause after entering the
PSTN pre-fix code, e.g.
9 , 11
etc. to enable you to get an
outside line.
You can therefore enter a
pause when storing a
memory number:
Press the QUICKDIAL button.
The handset In Use light
will flash.
KEYPAD
Enter the memory location
number (
0 - 9 ) under which
you want the number to be
stored.
KEYPAD
Enter the PSTN pre-fix code
e.g.
9 .
Press the REDIAL button.
This will add a 3 second
pause.
KEYPAD
Then enter the telephone
number.
Press the QUICKDIAL button.
You will hear a confirmation
tone.
To set the dialling mode
Switchboard access codes
24
Quickdial
Quickdial
Quickdial
Quickdial
ABC
2
0
1
When connecting your Synergy 500 to
a switchboard/PBX, you may need to
change the dialling mode from TONE
to PULSE.
R
Redial
Please note
Your Synergy 500 is supplied set to
tone dialling.
To enter a PSTN pre-fix code
and pause in the memory