Braun 6 - Manual (Page 23)

Page 21
Pre-Lift Operation Notes and Details
platform fully to the ground. The
attendant must view the platform
as it lowers to be certain the
entire platform reaches and
rests safely on the ground. Stop
pressing the DOWN switch if any
portion of the platform is ob-
structed while descending or the
entire platform does not reach
ground level for any reason
(contact with an obstruction,
mechanical failure, exceeding the
lift “floor-to-ground” capacity,
etc.).
After the platform is fully lowered
(entire platform reaches the
ground), the attendant should
continue to press the DOWN
switch to unfold the outboard roll
stop fully (ramp position). Note:
The roll stop must be fully
Roll Stop Latch: A spring-
loaded latch engages the out-
board roll stop when the roll stop
rotates upward from ramp posi-
tion to the vertical position (UP
switch is pressed to raise the
platform above ground level).
Note: The platform must raise
approximately two inches before
the latch engages fully (see
photos on previous page).
The latch disengages the roll stop
when the platform lowers fully
(reaches ground level) and the
latch foot contacts the ground
(latch raises above the roll stop).
Outboard Roll Stop and Roll
Stop Latch Operation: The lift
operator (attendant) must press
the DOWN switch to lower the
unfolded until the entire wheel-
chair (or standee) has crossed
the roll stop when loading or
unloading at ground level.
Discontinue lift operation
immediately if the roll stop or
latch do not operate properly.
Bridging: The L915 incorpo-
rates a bridging feature. This
feature stops the down travel of
the platform if the outboard end
of the platform contacts a raised
surface (such as a curb), pre-
venting the operator from lower-
ing the inboard end of the
platform.
Handrails: Dual handrails are
provided for wheelchair passen-
ger (or standee) use. The
handrails unfold automatically to