Braun 6 - Manual (Page 20)

Page 18
Pre-Lift Operation Notes and Details
Lift Features (continued)
(bridging) position when it
reaches vehicle floor level. The
roll stop must overlap the lift base
plate a minimum 1/2".
When the FOLD switch is
pressed and the platform folds
from floor level to the stow
(vertical) position, the roll stop/
bridge plate automatically travels
inboard to the stowed position.
Read warning posted on
opposite page. Discontinue lift
operation immediately if the
roll stop does not operate
properly.
Automatic Inboard Roll
Stop and Bridge Plate “IB”
Fully Folded
(vertical)
Inboard
Roll Stop
The inboard roll stop “IB”
must overlap the base
plate a minimum 1/2".
Fully Unfolded
(horizontal)
Inboard Roll Stop
(bridging position)
Fixed Inboard Roll Stop: A
stationary inboard roll stop is built
into “non-IB” L915 lift platforms
(shown in left-hand photo on
page 19).
Independent Hinged Bridge
Plate: “Non-IB” L915 lift models
are equipped with an independent
hinged bridge plate (shown in