3D Robotics 3DR DIY Quad - Manual (Page 15)

15
3 Mount GPS
Place the base of the GPS mast over
the four holes in the accessory plate
with the shorter side of the top of the
mast facing the left side of the plate
(the arrow-shaped holes in the plate
face forward). Add a mounting screw
to each hole, and secure with nuts.
Remove the adhesive backing from
the mast and place the GPS module
onto the mast with the connectors
facing the shorter side and the
arrow on the GPS pointing in the
same direction as the arrow-shaped
holes in the plate.
4 Insert SD card
Insert the micro-SD card into the
slot at the end of Pixhawk. The
APM:Copter sticker can be attached
to the front of Pixhawk.