3D Robotics 3DR DIY Quad - Manual (Page 14)

14
4 Pixhawk
assembly
Follow these instructions to assemble
the Pixhawk and accessory plates.
1 Mount Pixhawk
Separate the four foam pieces
provided with the Pixhawk kit, and
attach them to the bottom four
corners of the board. Mount Pixhawk
to the Pixhawk plate with the arrow
facing as shown below (towards the
less elongated end of the plate).
2 Mount buzzer and switch
The switch (button) snaps into the
round hole in the accessory plate.
Thread the switch cable through the
hole in the accessory plate from the
top, and gently pull the switch into
place. Using double-sided foam tape,
mount the buzzer to the underside of
the accessory plate.
BOTTOM VIEW