BenQ PB8260 - Manual (Page 41)

Maintenance 37
4. Use a small vacuum cleaner designed for computers
and other office equipment to clean the filters. Or
use a soft brush (such as a clean artist’s paintbrush)
to gently sweep the dust away.
If the dirt is difficult to remove or the filters are
broken, replace them. Contact your dealer or visit
BenQ website at www.BenQ.com for more service
information.
5. Replace the filters then press the covers back until
they click into place.
If the covers are not correctly seated in place, you
will be reminded by a message displayed on the
screen every three minutes. The projector will
automatically shut down after 10 minutes if there
has been no further action taken. Re-install the
filters securely, then turn on the power again.
Storing the projector
If you need to store the projector for an extended time, please follow the instructions below.
Make sure the temperature and humidity of the storage area are within the
recommended range for the projector. Please refer to the Spec. page (
51 ) in the manual
or consult your dealer about the range.
Retract the adjuster feet.
Remove the batteries from the remote control.
Pack the projector in its original packing or equivalent.
Transporting the projector
It is recommended that you ship the projector with its original packing or equivalent. When
you carry the projector yourself, please use the provided soft carry case.