Yamato Scientific BM410 Water Baths - Manual (Page 12)

10
4. Operational Procedure
How To Operate
Use the following procedure to operate water bath
Display after operation procedure Explanation
Turn the power “ON”.
ex.
The measured temp. is
25 ℃.
After you turn the power on, the unit
will start operation up to the
temperature last set.
→The display shows the current
measured temperature.
To change the set temp... Push “SET” key.
ex.
The last set temperature
was 40 ℃.
Push “SET” key.
→The display changes.
The formerly set temperature will
blink.
Push either the ▽or △
key.
ex.
Change the set temp.
from 40 ℃ to 50℃ during
operation.
Push either the ▽or △key to
change the blinking temp. to the
degree you desired.
●▽key reduces the value, and the
△key increases it.
Push “SET” key. After the temperature is set at
desired degree, push the “SET” key.
→The display changes from the set
temp. blinking to the current
measured temp., and the unit
begins operation up to the set
temp.
●If you set the temperature higher
than the current measured
temperature, the heater lamp will
light up and the unit will begin to
heat.