WORX WU330 710W SDS Hammer Drill 240V - Manual (Page 10)

10
MoUNtiNG of Bit iN keyleSS cHUck (wU330.3) (See fig.c2)
Grip rear collar of keyless chuck and rotate front collar until chuck is
open sufficient for tool to be inserted. Insert the tool into the chuck.
Grip rear collar and manually rotate front collar until tight. The locking
mechanism is automatically released when the front collar is rotate in
the opposite direction in order to remove the tool. (See Fig. C2)
oN/off SwitcH witH vaRiaBle SPeeD coNtRol
Depress to start and release to stop your tool. This tool has a variable
speed switch (1) that delivers higher speeds with increased trigger
pressure - speed is controlled by varying the pressure applied to the
switch (See Fig. D)
SwitcH lock-oN BUttoN
Depress the on/off switch (1) then the lock on button (2) (See Fig. D);
release the on/off switch first and the lock-on button second. Your
switch is now locked on for continuous use. To switch off your tool
just depress and release the on/off switch.
aUXiliaRy HaNDle
Slide the handle onto the hammer and rotate to the desired working
position. To clamp the auxiliary handle rotates the handle clockwise.
To loosen the auxiliary handle rotate the handle anti-clockwise
(See Fig. E).
warning! always use the auxiliary handle.
foRwaRD aND ReveRSe RotatioN coNtRol
With the drill pointing away from you, push the forward/reverse-lever
(3) to the left “
“for forward rotation. Push the forward/reverse-
lever (3) to the right for reverse rotation “ “.
5
6
7
8
9
15
2
1
13 14
A2 A1
D
C2
C1 B
F
E
G
1 7
WU330.2 WU330.3
WU330.3
WU330.2 WU330.3
2
12.1
12.2
15