WORX WU644 300W 1/3 Sheet Finishing Sander 240V - Manual (Page 9)

9
1
2
Intended use
Note:before using the tool, read the instruction book carefully.
iNteNDeD USe
the machine is intended for dry sanding of wood, plastic, filler
and coated surfaces.
RePlaciNg tHe SaNDiNg PaPeR
Before any work on the machine itself, pull the mains plug.
SelectiNg tHe SaNDiNg PaPeR
Depending on the material to be worked, different sanding paper
qualities are to be used: Use coarse grit paper to sand rough
surfaces, medium grit for smooth surfaces and fine grit for the final
surfaces.
RePlaciNg tHe SaNDiNg PaPeR
before placing on a new sanding paper, free the base plate (8) from
dust and dirt.
To ensure optimum dust extraction, the holes of the sanding paper
must match with those of the base plate.
1) Sanding Paper with Hook & loop System (See fig. a-1)
The sanding papers are placed directly onto the base plate (8). The
hole pattern in the sanding plate and sanding paper must match.
before placing on the sanding paper, free the base plate (8) from
dust/debris by lightly tapping against it.
2) Sanding Paper without Hook & loop System (See fig. a-2)
Lightly lift the clamp lever (7) and unlatch it.
Slide the sanding paper under the sand paper clamp and reinsert the
7
A-2
A-1