WORX WU644 300W 1/3 Sheet Finishing Sander 240V - Manual (Page 11)

11
empty the dust from the bag. To remove the bag slide the mounting
bracket out and away from the sander(See Fig D). To refit the bag,
firmly push the mounting bracket into the location on the sander
housing. (See Fig. E).
Empty or replace dust bag regularly to ensure optimum dust
extraction.
Operating Instructions
SWitcHiNg oN aND off (See fig. f)
To start the machine, press the on/off switch (1) and keep it
depressed. lock the pushed on/off switch by pressing the lock-on
button (3). To switch off the machine, release the on/off switch (1).
When locked on with the switch lock-on button (3), briefly press the
on/off switch (1) and then release.
vaRiaBle SPeeD coNtRol (oNly foR WU644)
With the variable speed control (2), the required speed can be
selected (also while running).
The required speed is dependent on the material and is to be
determined by a practical trial.
After longer periods of working at low speed, allow the machine to
cool down by running it for approx. 3 minutes at maximum speed
with no load.
1
2