WORX WU644 300W 1/3 Sheet Finishing Sander 240V - Manual (Page 3)

3
f) Dress properly. Do not wear loose clothing or jewellery. keep
your hair, clothing and gloves away from moving parts. Loose
clothes, jewellery or long hair can be caught in moving parts.
g) if devices are provided for the connection of dust extraction
and collection facilities, ensure these are connected and properly
used. Use of these devices can reduce dust related hazards.
PoWeR tool USe aND caRe
a) Do not force the power tool. Use the correct power tool for
your application. The correct power tool will do the job better and
safer at the rate for which it was designed.
b) Do not use the power tool if the switch does not turn it on
and off. Any power tool that cannot be controlled with the switch is
dangerous and must be repaired.
c) Disconnect the plug from the power source and/or the battery
pack from the power tool before making any adjustments,
changing accessories, or storing power tools. Such preventive
safety measures reduce the risk of starting the power tool accidentally.
d) Store idle power tools out of the reach of children and do
not allow persons unfamiliar with the power tool or these
instructions to operate the power tool. Power tools are dangerous
in the hands of untrained users.
e) Maintain power tools. check for misalignment or binding of
moving parts, breakage of parts and any other condition that
may affect the power tool’s operation. if damaged, have the
power tool repaired before use. Many accidents are caused by
poorly maintained power tools.
f) keep cutting tools sharp and clean. Properly maintained cutting tools
with sharp cutting edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc. in
accordance with these instructions, taking into account the
working conditions and the work to be performed. Use of the
power tool for operations different from those intended could result in
a hazardous situation.
SeRvice
a) Have your power tool serviced by a qualified repair person
using only identical replacement parts. This will ensure that the
safety of the power tool is maintained.
Additional safety points for your
finishing sander
Remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
Fully unwind cable drum extensions to avoid potential
overheating.
When an extension cable is required you must ensure it has
the correct ampere rating for your power tool and is in a safe
electrical condition.
Ensure your mains supply voltage is same as indicated on the
rating plate.
Your tool is double insulated for additional protection against a
possible electrical insulation failure within the tool.
Always check walls, floors and ceilings to avoid hidden power
cables and pipes.
After long working periods external metal parts and accessories
could be hot.
4
5
1
2
3
4
5
6
7