WORX WU407 1400W vibrafree Reciprocating Saw 240V - Manual (Page 13)

13
replaced at the same time. When changing worn carbon brushes,
use a slotted screwdriver to remove the brush holder caps. Take out
the worn carbon brushes, insert the new ones and make sure the
carbon brushes moving freely in the brush holders. Finally, secure the
brush holder caps. Work hints for your reciprocating
saw
If your power tool becomes too hot, set the speed to maximum and
run a no load for 2-3 minutes to cool the motor.
Always ensure the work-piece is firmly held or clamped to prevent
movement.
The pivot foot plate must be held firmly against the material being cut
to reduce saw vibration, blade jumping and blade breakage.
Maintenance
Remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use
water or chemical cleaners to clean your power tool. Wipe clean with
a dry cloth. Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls free of dust.
Occasionally you may see sparks through the ventilation slots. This is
normal and will not damage your power tool.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.