WORX WU407 1400W vibrafree Reciprocating Saw 240V - Manual (Page 11)

11
Note: The pivoting blade foot must be held firmly against the material
being cut to reduce saw vibration, blade jumping and blade breakage.
PeNDUlUM actioN coNtRol (See fig. G)
The pendulum action varies the down cutting angle of the blade for
increased cutting efficiency. This can also be adjusted during no load
running.
Do not use excessive blade force when cutting with the pendulum
action.
Warning: Make sure the pendulum setting is “0’ when
using the saw blade teeth facing up.
PeNDUlUM SettiNGS
0 Thin materials, fine cuts, tight curves.
1 Hard materials (e.g. steel & chipboard).
2 Thick materials (e.g. wood) & plastics.
3 Fast cuts (e.g. softwood). Cutting in the direction of the wood grain.
flUSH cUttiNG (See fig. H, i)
It is possible to make cuts extremely close to floors, walls and other
difficult areas. Insert the blade shank into the blade clamp with the
blade teeth facing up (opposite to normal working position). This
will make cuts closer to the work surface (See Fig. H). Using special
flexible blades insert the blade into the blade clamp with the blade
teeth facing down (normal working position). It will allow flush pipe
cutting (See Fig. I).
WooD cUttiNG
Always ensure the work-piece is firmly clamped to prevent
movement. For easier control use low speed to start cutting, then
increase to the correct speed.
6
7
8
1
9 8
2 3 4 5
7
6
8
A
D
G H
I
K L
E F
B
C
6
J
1
9 8
2 3 4 5
7
6
8
A
D
G H
I
K L
E F
B
C
6
J