Western Digital My Book Pro Edition II User Manual - Manual (Page 22)

MY BOOK PRO EDITION II
USER MANUAL
REPLACING A DRIVE – 19
8. Pull the drive bracket tabs towards each other and gently slide the bracket and
drive assembly up and out of the unit.
Note: Each drive is designated A or B by a color coded decal. The components
(bracket assembly, cables, connectors) for each drive match the color of the
decal.
9. Gently slide the replacement drive assembly into the unit, decal side up, until the
brackets click into place.
10. Reconnect the drive interface/power cable.
11. Replace the cage cap and tighten the screw.
12. Carefully replace the cover by gently sliding it into place and securing it with the
four screws.
CAUTION: DO NOT overtighten the screws. The threaded inserts could be
stripped if overtightened.
Important: Do not disassemble the drive and slider bracket assembly
components. Return the entire assembly intact to WD.
9 10
11 12