Western Digital My Net AC Bridge User Manual - Manual (Page 10)

PRODUCT OVERVIEW
7 MY NET AC WI-FI BRIDGE
USER MANUAL
Side components
Port LED indicators
Back
Component Description
Reset button To reset the bridge to factory default settings, press the Reset button for at
least 8 seconds and release. The power LED flashes on the bridge, indicating
a reset/reboot. This LED is solid when the reset/reboot has been completed.
Component Description
Power button Press to turn the bridge on. Press again to turn it off.
WPS (Wi-Fi
Protected
Setup) button Press this button to establish an initial connection between a WPS-
enabled router and the bridge.
Ethernet (LAN)
port(s) Use Ethernet cables to connect these ports to wired network devices
to these ports.
Power port Use the included AC power adapter to connect this port to the power
source.
Component LED Description
Ethernet port Link LED (Green) Steady on when a cable connects the port to
another Ethernet port.
Activity LED (Yellow) Blinks to indicate network activity of the
Ethernet port.