Vortex Optics RAZOR HD GEN II 3-18X50 RIFLESCOPE User Manual
Page 7
13
12
RETICL E
r
iflesco
pe
m
ounTing
To get the best performance from your Vortex Razor HD riflescope,
proper mounting is essential. Although not difficult, the correct steps
must be followed. If you are unsure of your abilities, it would be best to
use the services of a qualified gunsmith.
Rings and Bases
Mount an appropriate base and matching rings to your rifle according
to the manufacturer’s instructions. The Vortex Razor HD riflescopes
require 34 mm rings.
Vortex Optics highly recommends using the Vortex Precision Matched
34 mm ring sets which may be purchased from an authorized Vortex
riflescope dealer. These rings will mount to any Picatinny spec base.
If using an aftermarket base and ring setup, use the lowest ring height
that will provide complete clearance of scope and rifle—avoiding any
contact with barrel, receiver, bolt handle or any other part of the rifle.
A low mounting will help assure proper cheek weld, aid in establishing a
solid shooting position, and promote fast target acquisition.
Steps for Bore Sighting and Range Sighting
Be sure the L-TEC turret caps are correctly positioned with the 0 mark
on the turret cap indexed to the reference line on the turret body (see
page 11).
1. Loosen the turret top cover with a coin or
screwdriver to reveal the circular scale on the top
of the turret.
2. Use the wrench to loosen
three set screws located on cap
perimeters.
3. When adjusting, use the reference line and
circular scale (MOA or MRAD) in the center
of the turret housing to measure the desired
adjustments.
4. Using a screwdriver, turn the brass center
screw to make the adjustments changing the
bullet’s point-of-impact. No clicks will be felt
when making this adjustment.
5. Once desired zero has been achieved, re-tighten three set screws.
For best performance, turn in each of the three set screws until lightly
seated. Then, go back and continue to turn each screw a little bit at a
time until all three are fully tightened down.
6. Replace the turret top cover.