Vortex Optics RAZOR HD GEN II 3-18X50 RIFLESCOPE - Manual (Page 6)

11 10
RETICL E
L-TEC TM Turrets
This Razor HD Gen II riflescope features the fast, accurate, easily-read
L-TEC elevation and windage turrets
with integrated locking mechanisms
preventing accidental adjustments. The
turrets feature the L-TEC zero stop
which provides a reliable return to the
original zero when long distance shots
have been dialed. Note: The turrets
will allow a slight over travel (1/2
mrad or 1.25 MOA)
for shooters who
occasionally need to dial down below
their zero.
To make adjustments:
1. Pull the windage or elevation turret knob outwards to disengage the
lock.
2. Turn the knob in the desired direction: up or down for elevation
adjustments; left or right for windage adjustments.
3. After the shot, return knobs to the zero position. The elevation turret
can simply be spun clockwise until reaching a hard stop against the
zero stop. Then, turn the elevation turret just slightly (1/2 mrad or 1.25
MOA) in a counter-clockwise direction until the 0 mark on the cap
lines up with the indicator mark on the turret body.
4. Push turret knobs inwards to return to the locked position.
MOA/MRAD Adjustments
Each click of the Razor HD turret will move the point-of-impact either
.25 MOA or .1 mrad depending on the model. (Refer to MOA and MRAD
Adjustments on page 5 for more details).
Elevation Dial
Windage Dial
Adjusting the L-TEC Turrets for Bore and Range Sighting
Prior to making any zero adjustments, be sure the L-TEC turret caps are
correctly positioned with the 0 mark on the turret cap indexed to the
reference line on the turret body.
• Lift the elevation turret cap and rotate turret clockwise until it hits
a hard stop. Then, rotate just slightly (1/2 mrad or 1.25 MOA) in a
counter-clockwise direction until the 0 mark on the cap lines up with
indicator line on the turret body. Once aligned, push the cap back
down.
• Lift the windage turret cap and rotate until the 0 mark on the cap
lines up with indicator line on turret body. Depending on previous
cap orientation, you may have to rotate either clockwise or counter-
clockwise to do this. Once aligned, push the cap back down.
Align the 0 on turret
cap with indicator line
on turret body.