Vararam Tri-Power - Manual (Page 5)

Pull Away Towel.
Install main hoses as shown in figures. Squeeze the end of the hose on the air box to verify that you are on the edge of the box;
this is where you will want to install and tighten the hose clamp. This will avoid any bowing along the outer edge which would
cause an air dam effect. You may trim any access off once you have completed final fitting
Here simply remove the rubber grommet on the end of the factory hose and slide our supplied hose in place. Install on the pas-
senger side as shown, the factory hose has a self sealing plastic grommet, so all that is needed is to push it in place.
PVC