Vararam Tri-Power - Manual (Page 2)

Removing inner radiator flaps (look or feel for these on the left and right of your radiator) Determine which flaps you have,
hard plastic or soft flexible fabric. Most Chevy trucks have hard plastic- requires the removal of the upper plastic support. You
will replace this once the scoops are installed. This simply allows you easier access for removal.
Left side is soft Right side hard plastic
(Avalanche, Escalade & Denali) (Full size truck and Tahoe)
ALL GM’s---- including Avalanche and Escalade owners, simply reach into the cavity and remove these, you can just pull on
them, they are held in with the same black plastic grommets as the wiring loom. There will be one up high and one down low
and one on the outside most edge, three totals per side. This factory block off material is fairly soft and can be removed in
seconds, compared to popping the grommets one at a time, with cutters or a screwdriver.
Step two
Tech Note
(Read this through, the Avalanche and standard trucks use different components here, this covers
Escalade and GMC as well.)
Next to your Radiator on the left and right side are some flexible factory block offs; these will need to be removed.
Note: removal of plastic cover
is not nessesary for Avalanche
trucks.