Vararam Tri-Power - Manual (Page 4)

Install supplied brackets as shown, they are slotted, so simply slide them in place and tighten the 10mm bolt that is under the
core support on both sides. Install supplied screws and washers and tighten completely.
With kit off of vehicle install mass airflow meter as shown and tighten hose clamp, air meter should be verticle. Using supplied
red hose fit the 1inch long piece over the air meter 1st; this is used to size up the outside diameter. Tech note, lube the inside of
the hose as shown with some WD-40 for an easy slip over fit. Fit longer angle of hose to the top side of the throttle body and
tighten in place, lube the inside of hose with WD-40 for slip fit.
Tech note 2. Make sure there are no gaps around the outside of the hose to throttle body fit as shown.
Tech note 3-.Pad the backside of the radiator fans by using a towel, simply drape it over, this way you won’t scratch your kit or
yourself! With the air meter attached and both red hoses in place you can now lower the kit in place.
Pay close attention here!!!!
You will lower the kit in squeezing and overlapping the red hoses. Simply work the top of the hose in with your finger as
shown. Follow the pictures and be patient here. Once in place install all clamps on the red hoses as shown.