Unisteer 8051500 Universal Electra-Steer - Manual (Page 5)

pg. 5
655740
Electra Steer Diagnosis Trouble Code Reading and Code Clearing
1. Verify that your trouble code light is on steady.
2. Next, take your purple or brown wire and connect it to a good clean ground. You will have to make sure it
is a solid ground to get the LED to blink or flicker and you may have to use a jumper wire to extend the
wire’s length. Once you see the LED flicker or blink wait for LED to start blinking a code.
3. The light will flash in a sequence like 1 and then 123. This code flash would be interpreted as a code 13.
The code will repeat itself 3 times and then go to the next code if there is one in the system. You need to
wait until all the codes are read and recorded.
4. Once you know what the codes are you can use this chart to tell where or what the problem may be.
5. Once you have determined what the problem is and make the necessary repairs, you can proceed to clear
the codes by running a jumper wire from the white wire with the single spade connector on it to a good
ground.
6. Verify the ignition is off. Place the white wire to ground. Turn key on, wait 5 seconds and the light should
go out. When the light goes out turn off ignition and remove jumper wire. Once all repairs are made turn
ignition on and see that light proves out normally. This is all there is to it.
Trouble Code Problem Diagnosis
41-42-43-44-45-51
Electric motor
Malfunction
Replace Motor Assembly
11-13-14-15 Torque Sensor Replace Motor Assembly
52-54-55 ECU Malfunction Change Computer
22 No Engine Input Change Computer
21-23-24 No Speed Signal Change Computer
12
Wiring or
Electrical
Verify 12 volts at green wire. Verify good
ground. Soldier all connections. Check
for bad connections or broken wires.
We welcome your suggestions & comments to make this or any of our installations better! If you
have any questions/problems regarding this product please contact us at:
UNISTEER
Performance Products
1555 Enterprise Parkway
Twinsburg OH 44087
800-338-9080
WWW.UNISTEER.COM
Created on 01/08/2008
Last Revised 6/30/2014
Copyright © 2009 by Maval Manufacturing Corporation All rights reserved.
No part of these materials can be reproduced or utilized in any form or by any means, electronic
or mechanical, including photocopying, recording or by any information storage and retrieval
system, without permission in writing from Maval Manufacturing Corporation.