Unisteer 8020490 Tri-Five Chevy Steering Column Bushing 1955-57 - Manual (Page 2)

pg. 2 655400
8. Cut the shaft of the steering box as close to the housing as possible.
9. Disassemble the upper half of the steering column by removing the 3 Phillips head
screws from the lock plate.
10. Remove the turn signal housing carefully. Do not damage the wires.
11. Disassemble the lower portion of the column by removing the 3 hex screws on the tube.
12. Remove lower bearing and the inner column shift tube.
13. Measure from the bottom of the column up 1.75”, and cut very straight. There will be 2
existing holes in the tube that line up with the new column bushing. The third hole will
need to be drilled. Place the column shaft along side the column and calculate the length
needed, so that 1-
1.5” of shaft will extend out the bottom of the column. Measure
carefully. Clean and sand the shaft until it fits the new bushing snugly.
14. Reassemble the column completely. And insert the new bushing last.
15. Fasten the new bushing with the two screws.
If you have any questions or problems regarding this product please contact:
UNISTEER
Performance Products
1555 Enterprise Parkway
Twinsburg OH 44087
800-338-9080
WWW.UNISTEER.COM
(6/11/2014)
Copyright © 2009 by Maval Manufacturing Corporation All rights reserved.
No part of these materials can be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying, recording or by any information storage
and retrieval system, without permission in writing from Maval Manufacturing Corporation.