Unisteer 8051460 Ididit Electra-Steer Column - Manual (Page 3)

Page 3 655970
7. Next remove the shaft and make the notch with a grinder wheel in the spot you marked earlier. Install
the shaft into the lower coupler on the motor and tighten the pinch bolt to 30 ft lbs.
8. Next install the column tube onto the lower collar of the motor and secure it to the motor using the
supplied hardware.
9. Next install the plastic bushing in the lower part of the column tube. To do this push the bushing over
the shaft and into the tube and tap it down by evenly walking around the edge with a small hammer.
Once
it’s seated you can drill a 1/8” hole through the column tube and just slightly into the plastic
bushing. You can secure it with the supplied roll pin by tapping it into place.
10. Connect the rest of your joints and shafts you need to adapt to your application. Remember to make
sure you have secured your column to the firewall and your dash. Improper installation will cause
failure and possible damage. Make sure all hardware is installed and torqued to spec.