Unisteer 8012000-01 Ford Fairlane & Ranchero Rack 1966-1967 - Manual (Page 4)

Page 4 656800
5. From inside the vehicle remove the horn pad and retaining nut then remove the steering wheel. From
under dash remove the 2 main mounting bolts. At the firewall, remove the plate that holds the column
in place. Mark and disconnect the wires from the vehicle to the column. Remove the steering column.
6. Fairlane only. At the top of the column there is a bearing. On top of the bearing there is a snap ring to
remove. Once it is removed slide the column shaft down out of the column tube. Once it is out you
need to install the provided column bearing in the bottom of the column using a hammer to tap it in
place until fully seated against the tube.
7. Fairlane only. You can now install the column tube into the car and put it back to the stock location.