Unisteer 8011440 Full Size Ford 1960-1964 - Manual (Page 7)

Page 7 656160
14. Once you have your belt installed and tightened you will need to connect your lines. The return line
goes to the plastic nipple on the side of the reservoir. The pressure line goes to the fitting on the top
of the pump. Once the lines are on and tight you can top off the reservoir with power steering fluid.
15. Start the vehicle and let idle for 10 seconds and shut it off. Do not turn the steering wheel while the
vehicle is running. Top off the reservoir and start the vehicle again turn the wheels both ways slowly
to purge air from the system and check for leaks. Recheck fluid level and top off as needed.
16. You will need to have your vehicle aligned at a shop. Congratulations on a perfect install.
If you have any questions or problems regarding this product please contact:
UNISTEER
Performance Products
1555 Enterprise Parkway
Twinsburg OH 44087
800-338-9080
WWW.UNISTEER.COM
Created on 7/8/2010
Last Revised on 6/24/2014
Copyright © 2010 by Maval Manufacturing Corporation All rights reserved.
No part of these materials can be reproduced or utilized in any form or by any means, electronic
or mechanical, including photocopying, recording or by any information storage and retrieval
system, without permission in writing from Maval Manufacturing Corporation.