12 wall mounting the spectrum plus, Telephone, Desk mounting – Telematrix SP100 User Manual

Page 12

Wall Mounting the Spectrum PLUS

Telephone

To install the wedge for desk mounting, be sure the lock mechanism is positioned to the left

clear of the locking arm. Place the wedge in the slots, wide end toward top of phone base

unit, and slide the wedge upward into position. Lock the wedge into place.

Desk Mounting

2. The Spectrum PLUS

has provisions for a

mounting wedge that must be correctly positioned.

This wedge allows the telephone to be viewed at a

correct angle when the phone is wall mounted.

Remove the wedge from the phone base (figure 2).

3. Secure the line cord, coil cord and any wiring in

place prior to installing the wall mount wedge. The

wall mount base has extra large wiring channels

and strain relief poles for containing the wires in a

neat and orderly way. Wrap the wires around the

strain relief poles and then secure the wires

through the channel.

4. To wall mount, place the narrow edge at the top

edge of the phone base and slide the wedge up-

ward into place (figure 3).

5. Lock the wall mount into position by sliding the

locking button to the right (figure 4).

Note: A 6-inch line cord is provided for when

the telephone is to be wall mounted. Connect

one end of the line cord to the phone jack and

the other end to the wall jack. Be sure to con-

nect and line cord before placing mounting

wedge on the bottom base.

figure 2

Replace Mounting Wedge

figure3

Replace Mounting Wedge

figure 4

Lock Mounting Wedge

The Spectrum PLUS

was designed to be

conveniently wall mounted without requiring

additional hardware.

Follow these easy steps:

1.The handset retaining clip must be in the correct

position to secure the handset into the handset

cradle. Engage the clip with your fingers and pull

the clip forward (towards you), rotate the clip 180º

and snap the clip back into place (figure 1). The

retaining clip cannot be removed.

RETAINER CLIP

figure 1

1. U N S NA P
2. R O TAT E 1 80 .
3. SN AP I NT O P LA C E.

NOTE: CLIP IS

1.LIFT CLIP OUT WITH
FINGERS. IT CANNOT BE
REMOVED BECAUSE IT
IS SPRING LOADED.

2. ROTATE THE
CLIP 180

AND

IT WILL SMAP
BACK INTO THE OPPO-
SITE POSITION. AN