Telematrix 9600 Series - Manual (Page 7)

TouchLite (Message Waiting) 1-touch retrieval - # 17
TouchLite is an innovation that integrates the visual message waiting lamp and a speed
dial key onto one. It allows easy access for guests to retrieve messages.
When the message waiting lamp lights this noties the guest that a message is waiting. A
simple press of the Red TouchLite bar connects the guest to the message center or front
desk. TouchLite also adds an additional memory location to this telephone.
6 9
Calling...
Placing a Call Using the Handset - # 1
• Lift the handset.
• Dial out by using the numeric dial pad on the handset or by pressing Line 1 on the
Handset then a speed dial location.
Receiving a Call Using the Handset or Speaker - # 1 & # 15
• On a single line telephone, when the phone rings, either lift the handset and press the
activated Line 1 button # 33 on the handset, or press the speaker key # 15, to begin
the conversation.
• On a two line telephone, when the phone rings, the line LED indicator will blink to
show which line the call is coming in on. Lift the handset and select blinking Line key to
begin conversation, or select the blinking line key on base then press the speaker key,
to begin the conversation.
Placing a Call Using the Speakerphone - # 15
The DECT Series speakerphones are equipped with a high quality speakerphone feature
to allow hands-free operation. To use, simply press the “Speaker” key # 15 when placing
or answering a call. The telephone line will activate automatically. The “Speaker” key
will light up indicating that the speakerphone is in-use. To hang up, press the “Speaker”
key again.
Handset Locate Key - # 13
The DECT Cordless Series is equipped with a handset locator feature key located on
the base # 13.
Simply press the “LOCATE” button on the base unit.
= LOCATE key.
The handset will beep for about 15 seconds. Once the handset is located, press the
ON/OFF key to activate your handset.
Redial Key - # 11 (on base) & # 35 (on handset)
The REDIAL key is used to automatically redial the last number manually dialed from the
numeric dial pad on the base or handset.
= REDIAL key
Simply engage telephone by pressing Handset Line 1 or Line 2 ON/OFF key - or Line 1
or Line 2 key on the base ON/OFF key, then press REDIAL button on handset or base
to dial last number dialed.
Handset Message Retrieval - # 34 “1”
When the DECT handset is “idle”, pressing and holding down dial key “1” on the DECT
mobile handset, this will dial the pre-programmed contents of the TouchLite button on
the DECT base unit.
Message Retrieval...
Note: You may have up to
three cordless handset
charging units operating off
one DECT base unit.