Telematrix 9600 Series - Manual (Page 6)

Speaker & Mute Key Connecting & Status Indicators - # 15 & 19
Speakerphones are equipped with LED indicators to show the current feature key status.
• Press Speaker or Mute Feature Key to use that service - LED will light Green when
that key is IN USE.
Indicators...
5
10
Features...
Using the Mute Feature on Speakerphones - # 19
A “Mute” key is provided to allow privacy during a background conversation. When the
“Mute” key is activated, the microphones in the handset and speakerphone are disabled.
When the “Mute” feature is activated, the caller will not hear your voice. The “Mute”
key indicator will light to show that the feature is activated. To de-activate, press the
“Mute” key again.
Using the Conference Key - # 32 (located on Handset) (2 line models only)
The “Conf.” key is used to establish a 3-way conversation. The conference feature is
activated by a “soft” key that will automatically reset when hung up.
A 3-way “Conference” call can be established while using the handset.
To use the “Conf.” feature:
1. Place the line that is currently in-use on Hold by pressing the “Hold” key.
The line status indicator will turn from Green to Red.
2. The second call can be established by selecting the idle line key and dialing the call.
3. When the second call is established, activate the 3-way conference call by pressing
“Conf.” key. Line 1 and Line 2 will automatically “bridge” together and all three
parties can now converse.
4. To end the call, simply hang-up by placing the handset back in its cradle.
5. If you wish to continue speaking with one of the callers and wish to “drop” the other
caller, simply press the line key of the caller you wish to continue speaking with.
The other caller will automatically drop-off.
Charging the Handset Battery: (On Base and Charging Station)
The handset Battery is a Ni-Cd battery. This battery requires a Full charge prior to use
to ensure long life. To charge the battery, complete the installation procedure by plugging
the power source into the wall outlet and the telephone base or charging station.
Install the battery the battery per below instructions, inserting battery plug into receptacle.
Place battery into opening in handset, press into place, then replace cover and place
handset into base (face down) or charging station (either facing front or back).
Battery Life - When Completely Charged:
Talk time: 7.5 hours
Standby: (handset off hook) 6 days
Charge for 24 hours to ensure a fully charged battery
Installing Battery Into Handset:
1. Open cover with small screwdriver.
Do Not open more than 1/2 inch.
2. Grip handset and depress cover at hinged end.
3. Slide cover off, exposing battery compartment.
4. Slide battery plug into receptacle, matching
up slot and opening on receptacle
5. Slide battery into battery compartment.
Do Not Force Battery!
6. Press on back end of battery to snap
into place.
7. Place hinged end of cover into slot,
then press down and snap into place.
Handset Battery...