beautypg.com

Telematrix 9600 Series Auto-Sync User Manual

Page 8

background image

8

REDIAL
The 9602 series can automatically redial the last number
dialed. Off-hook, press the REDIAL key to redial the last
number.

USING THE HOLD KEY
The HOLD key places the call on hold locally at the cordless
telephone.
1. With a call active, press the HOLD key on either the
To remove a call from hold:
1. Press the line key of the call on hold. This will remove the
call from hold, making the call active again.
2. The red LED will return to steady illumination, indicating
the line is active.
To change phones after placing a call on hold:
1. Place the call on hold as above.
2. Pick up the call at another telephone that is on the same
line. The telephone will activate the line and remove the hold
at the original telephone.

TO MUTE THE SPEAKERPHONE
1. Press the MUTE key on the base unit. The red LED above
the MUTE key will illuminate. The party on the other end
will not be able to hear you when the MUTE LED is lit.
2. Press the MUTE key again to turn off the mute feature.
The MUTE LED will go out.

ADJUSTING HANDSET RECEIVE VOLUME
The handset has five(5) volume levels. To adjust the handset
volume, locate the volume up/down keys, located on the
handset, below the “0” key. Pressing the down key will
decrease the volume level, while pressing the up key
will increase it.

AUTO DIAL KEYS
The 9602 series has either five (5) or ten (10) programmable
guest service (auto dial) keys, depending on the model you own.
These keys can be programmed to automatically dial telephone
numbers, or to activate telephone system features. To program the
auto dial keys (programming can only be done from base unit):
1. With the phone “on hook” (inactive) and the faceplate
removed, press the recessed STORE key (see diagram).
2. Enter the desired telephone number (up to 15 digits in
length) to be stored. To enter a “pause” in the number
string, press the REDIAL key as necessary.
3. Press the STORE key again.
4. Press the auto dial key where the number is to be stored.
Programming is now completed for that auto dial key.
To program additional keys, repeat this process.

CONFERENCE
The “CONF” key allows for three-way conversations. Depending
on the situation, you may initiate a conference call using one of
these methods:
User initiates two calls:
1. Place call to first party, then place them on hold by
pressing the HOLD key.
2. Using the second line, place call to second party.then
place them on hold by pressing the HOLD key.
3. Activate the 3-way conference call by pressing HOLD/CONF key on the handset.
User initiates one call:
1. After receiving a call from first party, place them on hold