Regency Horizon HZ54EPV Large Gas Fireplace - Manual (Page 50)

50
Regency Horizon HZ54EPV Gas Fireplace
INSTALLATION
19) Attach the receiver to the unit with the velcro strip. Place the receiver
in front of the ground lug on the left side of the unit - inside the bottom
frame of the unit - follow steps 15-19 to complete installation.
18) FOR GTMF INSTALLATIONS ONLY: Install the fan control module into
the unit through the open fan access panel. Plug the fan control module
into the receptacle in the unit (left side - fl oor of unit). Plug the fan into
the fan control module and connect GTMF remote (see GTMF installation
instructions in this manual).
15) Reverse Steps 8 through 5.
16) Install the fan air defl ector - it hooks to 2 brackets on to the bottom lip of
the unit, to the right of the receiver.
17) Reverse Steps 4 through 1.
Air defl ector
TO REMOVE THE FAN
1) Turn the power off.
2) Reverse the above instructions.
Maintenance: The sealed bearings are lubricated, there is no need to lu-
bricate them further. (Extra lubricant will cause more lint and dust buildup
- causing the bearings to prematurely fail).
Regular cleaning and vacuuming of the fan area will add to the life of the
motor.
IMPORTANT:
These fans collect a lot of dust from within your home. Ensure you
maintain these fan motors on a regular basis by vacuuming
the fan blades and housing using a soft brush nozzle.
Air defl ector
Bracket
FAN
RECEIVER
Top View
FCM
7”
10”
6-1/2”
CONTROL PANEL