Sunnex HM2017-44 - Manual (Page 4)

Sunnex HM Light Service & Installation Manual 4
2.1 HM LIGHT Mobile (HM1006-37W)
1. Place the pole (2) in the center housing (4)
2. Press down until you feel resistance.
Assemble the clamp plate (5) using the provided screw (7)
and washer (6). Do not tighten the screw. The teeth on the
plate should face inwards.
3. Insert each of the 5 legs into the center housing, and
place the 2 lockable casters on opposite sides.
4. Tighten the screw (7). Secure the legs in the housing by
lining up the teeth on the clamp plate (5) with the holes in
the legs.
2.2 HM LIGHT Wall – Articulating Arm (HM28002W)
Wall Mount - 20W - Plug-in transformer
A. Remove the screws in the wall plate (1&2).
B. Remove the wall plate from casing (2)
C. Drill 4 holes (8mm) in alignment with the holes in wall
plate. Make sure plate is leveled. NOTE! Wall plate must
be mounted to wall stud or structural member.
D. Insert the anchors into the holes and attach the wall
plate with the screws provided.
E. Attach wall casing to the wall plate with provided screws.
F. Make sure that the wall casing is securely fastened to
the plate and adjust and tighten the arm as needed.
G. Plug the transformer into power outlet and turn on lamp
with switch on back of lamp head.
CAUTION! The arm is equipped with friction joints. Do not tighten the joints excessively as
this will cause uneven movement and could damage the arm.
d