Summit SWC1875B - Manual (Page 9)

9
5. Screw the alternative left top hinge ○8 , included in the fittings, on the left hand side of cabinet. (Fig. 3)
6. Set the upper glass door to the designated position. Then turn around the middle hinge 180° and refit
it on the opposite side by screwing in the three bolts. Level the door by adjusting the three fixing bolts.
And make sure that the spacers which the hinge pins sit on are correctly positioned. (Fig. 3)
7. Set the lower glass door to the designated position and install the two lock screws 1 to connect the
door shaft assembly 2 with the glass door and tighten them before the door is leveled. (Fig. 1)
8. Remove the handles from the left side of the doors and install them on the right side. (See next
section.)
INSTALLING THE STAINLESS STEEL HANDLE
This appliance includes a stainless steel handle that is not required to
operate the unit. To install the handle, follow the instructions below:
Locate the handle 1 over the pins 3 of the door and tighten the handle
by screwing in screws 2 with an Allen wrench.
OPERATING YOUR APPLIANCE
It is recommended you install the appliance in a place where the ambient temperature is between 72º and
78ºF (23º-26ºC). If the ambient temperature is above or below the recommended temperatures, the
performance of the unit may be affected. For example, placing your unit in extreme cold or hot conditions
may cause interior temperatures to fluctuate. The range of 41º-72ºF (5º-22ºC) may not be reached.
RECOMMENDED TEMPERATURE SETTINGS
Conservation 49 ~ 57ºF 10 ~ 14ºC
Red Wines 58 ~ 72ºF 15 ~ 22ºC
Dry/White Wines 48 ~ 57ºF 9 ~ 14ºC
Rosé Wines 49 ~ 51ºF 10 ~ 11ºC
Sparkling Wines 41 ~ 47ºF 5 ~ 8ºC
CONTROL PANEL for SWC1535B
1 2 3