Summit SWC1875B - Manual (Page 11)

11
UP
Used to increase (warm) the set temperature by 1°C/1ºF.
DOWN
Used to decrease (cool) the set temperature by 1°C/1ºF.
Indicator Light
The indicator light is located at the right lower corner of the display. The indicator light will be on
when the multi-key function is selected. To perform the multi-key function, press and hold the first
key, then press the additional key(s) for at least 5 seconds and then release all the keys
.
ºF/ºC Selector
Select the temperature display setting in Fahrenheit or Celsius degree. To change the temperature
from Fahrenheit to Celsius or from Celsius to Fahrenheit, press and hold the LIGHT key for 5
seconds.
Setting the Temperature Control
• The unit has two separate temperature zones. The temperature of both zones can be set
between 41ºF and 72ºF (5ºC and 22ºC). The LOWER temperature zone is ideal for storing
white and red wine at a setting of 55°F to 72°F (13°C to 22°C). The UPPER temperature zone is
suitable for storing champagne and white wine at a setting of 41°F to 55°F (5°C to 13°C).
• When the unit is plugged in for the first time, the unit will power up automatically to the preset
defaults. The preset temperature at the factory for the UPPER temperature zone is 50ºF (10ºC)
and for the LOWER temperature zone is 60ºF (16ºC).
• You can press the left side UP and DOWN keys to control the internal temperature of the
UPPER temperature zone and press the right side UP and DOWN keys to control the internal
temperature of the LOWER temperature zone. When you press the two keys at the same time,
the display will show the last temperature set previously.
• NOTE: The temperature set for the LOWER temperature zone must always be just as high
as or higher than that in the UPPER temperature zone. For optimal performance, the set
temperature of the two zones should differ by at least 8°F.
• The temperature that you desire to set will increase 1ºC or 1ºF if you press the UP key once, on
the contrary the temperature will decrease 1ºC or 1ºF if you press the DOWN key once. The
display flashes while you make the setting.
• After the temperature has been set, the display shows the current inner temperature of the
particular temperature zone.
• To view the set temperature at any time, press the UP or DOWN key; the set temperature will
temporarily
flash in the display for 5 seconds. Then the display shows the current inner
temperature again.
NOTE:
• If the unit is unplugged, or power is lost or turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the unit will not start.
• When you use the unit for the first time or restart the unit after it has been shut off for a long
time, there could be a few degrees variance between the temperature you select and the one
indicated on the LED readout. This is normal and is due to the length of the activation time.
There should not be a problem once the unit has been running for a few hours.