Summit SBC590 User Manual

Page 14

REVERSING THE DOOR HINGE (Optional)

Required tools: Phillips screwdriver

Disconnect power from the unit.

Remove each of the screws on the top of the unit. There should be a total of seven (3 on

the hinge side, 4 on the unhinged side). Be careful not to lose or discard the screws.

Remove the TOP HINGE and WASHER (see picture at bottom) and set aside.

Lift the door straight up and off of the BOTTOM HINGE.

Remove the screws fastening the BOTTOM HINGE and COVER to the bottom of the beer

cooler cabinet. There are five screws total (4 for the hinge, 1 for the cover).

Move the BOTTOM HINGE and COVER

each to the opposite side of the bottom of
the cabinet. Completely tighten the four
BOTTOM HINGE screws, and
tighten the COVER screw gently.

7. Remove the two screws fastening the DOOR STOP SPACER and the DOOR STOP to the

bottom of the beer cooler door, and move the spacer and stop to the opposite side.

8. Re-insert and completely tighten the screws.

9. Install the door onto the washer and hinge pin of the BOTTOM HINGE.

10. Align the top hinge WASHER with the HINGE HOLE in the top of the door. Then, insert the

TOP HINGE pin through the WASHER and into the HINGE HOLE.

11. Fasten the TOP HINGE with three screws and move the remaining four screws to the

opposite side. Completely tighten the seven screws.