Blaupunkt CANBERRA RCM 85 - Manual (Page 9)

25
Canberra RCM 85
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
Switching off security coding
• Turn off the radio.
• Press preset buttons 1 and 4 simulta-
neously and hold down while switching
the set on again.
The display shows “CODE”.
•
Now enter the code number to be found
in the car radio passport and confirm
(see example under “Re-start ...”).
Security coding is now switched off.
Optical indication for extra
security
To indicate that your unit is equipped with
security coding, you may let an LED installed
in the non-detachable part of the front panel
flash for extra security when the car is statio-
nary.
For this, the following requirements must be
fulfilled:
Permanent 12 V supply and the + ignition
lead must be connected correctly (as illustra-
ted in the installations instructions).
„LED 1“ must be adjusted in the DSC mode.
Read “DSC programming - CODE-LED”.
After 20 unsuccessful attempts, the display
will show “SERVICE”. In this case you can no
longer re-start the unit.
Notice:
Keep your car radio passport with the code
number in a safe place in order to avoid
“unauthorised access” to your car radio.
When the security code system is activated,
the unique code must be entered each time
the power to the unit was interrupted.
The radio will function again as soon as you
have entered the correct code.
If you have lost your radio passport and
forgotten the code number, your radio can
only be made operable again by one of our
authorised service workshops (subject to
payment).
Switching on security coding
To activate the coding system:
•
Turn off the radio.
• Press preset buttons 1 and 4 simulta-
neously and hold down while switching
the set on again.
The display briefly shows “CODE” and the
unit will switch on.
•
Release preset buttons 1 and 4.
Now the security coding system is active.
The display will briefly show “CODE” each
time the set is turned on.
Re-start following an interrup-
tion of the power supply
(coding system is activated)
• Turn on the radio.
The display shows “CODE”.
• Briefly press preset button 1; the dis-
play shows “0000”.
• Enter the code number given in the
Blaupunkt car radio passport:
Example: The code number is 2521.
- Press preset button 1 twice; the dis-
play shows “2000”.
- Press preset button 2 five times; the
display shows “2500”.
- Press preset button 3 twice; the dis-
play shows “2520”.
- Press preset button 4 once; the dis-
play shows “2521”.
• To confirm the code number:
Press the upper part of the rocker
switch .
If you have entered the correct code, the unit
will now be ready for use.
If the display shows “CODE ERR”, you have
entered a wrong code. Re-enter the correct
code after the waiting time (“CODE” will ap-
pear in the display).
If you switch off the set while it is blocked, the
waiting time will start anew as soon as the
radio is turned on again.