Blaupunkt CANBERRA RCM 85 - Manual (Page 14)

Canberra RCM 85
30
b) Switch off the priority for traffic an-
nouncements:
•
Press TA.
“TA” will disappear from the display.
Automatic seek tuning start
(tape operation)
When leaving the reception area of the tuned
in traffic programme station while listening to
a tape, the system will automatically start
searching for a new TA programme.
If no such station is found within approxima-
tely 30 seconds, tape operation will be stop-
ped and a warning beep will sound.
To switch the warning beep off, proceed as
described above.
Adjusting the volume for traffic
announcements and the warning
beep
This volume was preset at the factory.
You can alter the value using the DSC function
(see “DSC programming, TA”).
Tape operation
Inserting a tape
• Turn on the set.
• Insert a tape.
Insert the tape with side A or 1 showing up, the
open side facing to the right.
= Press to eject the tape.
The tape will be played in the direction used
last.
“TR1-PLAY” in the display means that track
1 or A is being played.
Removing a tape
• Press .
The cassette will eject.
Fast Forward/Rewind
Fast Forward
•
Press FF.
At the end of a tape side, the mecha-
nism changes directions automatically
to play the other side.
Stopping Fast Forward operation
•
Press FR.
Fast Rewind
•
Press FR.
At the beginning of the tape, the me-
chanism will automatically start play-
back.
Stopping Fast Rewind operation
•
Press FF.
To switch to the other tape side:
Press simultaneously.
TR1-PLAY or TR2-PLAY shown in the
display.
FR : Fast rewind; stop by pressing FF.
FF : Fast forward; stop by pressing FR.
PROG selector
To change the tape direction during cassette
playback
• Press FR and FF simultaneously.
At the end of a tape side, the mechanism
changes directions automatically to play the
other side (Autoreverse). The display shows
“TR1-PLAY” for track (side) 1 or A or “TR2-
PLAY” for track 2 or B.