Summit DW18 User Manual - Manual (Page 22)

20
USA
B
C
1
A
2
B
1. Remove the lower rack from the
machine.
2. Turn the coarse filter counterclockwise
to the left and pull it out in an upward
direction A.
3. Pull out the main filter B.
4. Press on the two tabs of the coarse filter
and remove the micro filter C.
5. Clean the filters thoroughly under running
water. Use a brush if necessary.
6. Replace main filter.
7. Replace the micro filter and the coarse
filter into the main filter.
8. Twist it clockwise until it clicks into the
place.
10.2.2 CLEANING THE SPRAY ARMS
Notice :
Dirt and/or calcium residue may block the
nozzles on the spray arms. For this reason,
regularly check the spray nozzles.
1. Lower spray arm
2. Upper spray arm
1. Remove the lower rack from the
machine.
2. Pull off the lower spray arm in an upward
direction A.
3. Loosen the fastening screw of the upper
spray arm and pull off the spray arm B by
a downward motion.
4. Clean the spray arms under running
water.
5. Replace the lower spray arm in a
downward direction.
6. Replace the upper spray arm and tighten
the fastening screw by turning it around
to the left.
7. Insert the lower rack.
A
2
3
CAUTION
Do not operate your dishwasher without
a filter. You will damage your machine.
Ensure that your filters are correctly
installed.
CAUTION
Ensure that the fastening screw is tight
on upper spray arm.