Summit DW18 User Manual - Manual (Page 16)

14
USA
CANCELLATION OF A PROGRAM
To cancel a program while the dishwasher is
running:
1. Open the door gently.
2. Press and hold Start/Pause/Cancel button
for 3 seconds. The indicator light will start
flashing.
3. Close the door.
4. The dishwasher will drain the water inside
the machine for 2 minutes. At the end of the
cycle a beep will sound. You can choose and
start a new program.
WARNING
Depending on the stage of the program
you have cancelled, there may be
detergent residue or rinse aid inside the
machine and on the dishes. Make sure
the items in the dishwasher are not used
before washing properly. Ingestion or
inhalation of detergent or rinse aid may
cause serious injury. Avoid contact with
skin and eyes and keep children and
infirm persons away from these materials.
PROGRAM CHANGE
To change the program selection while the
dishwasher is running:
1. Open the door.
2. Press Start/Pause/Cancel and select a
new program.
3. Press Start/Pause/Cancel again, to start.
WARNING
Depending on the length of the terminated
program detergent and rinse aid may still
be in the dispensers.
Ingestion or inhalation of detergent or
rinse aid may cause serious injury. Avoid
contact with skin and eyes, and keep
children and infirm persons away from
these materials.
CHANGING WARNING SOUND VOLUME
Press and hold Half Load / Tablet Detergent
key for 5 seconds until S:03 appears on the
display. Every time you press the Half Load
/ Tablet Detergent key, the warning sound
level will change as - - Off, S:01 Low, S:02
Medium, and S:03 High. After selecting the
sound volume, wait for 10 seconds to save it.
Factory setting of your machine is S:03.
8 RINSE AID LEVEL INDICATOR LED
Reset.
3 sec.
Reset.
3 sec.
SALZ
TU
Z
SA L T
S
E
L
Dark : Sufficient rinse aid
Light: Refill rinse aid
Visual indicator
If this indicator
light comes on,
you need to refill
rinse aid.
You can also tell
whether rinse aid
must be refilled
by looking at
the rinse aid
dispenser. When the visual fill indicator
is dark, there is enough rinse aid in the
dispenser.
When the color is light, open the
dispenser and refill rinse aid.
3 SALT LEVEL INDICATOR LED
(MODEL DEPENDING)
When this
indicator light
comes on,
you must refill
special salt.
Only use special
dishwasher salt in
your machine to
soften the water.
The salt content can be read on the
container for the salt. When the visual fill
indicator is dark, there is enough salt in
the container.
When the color is light, open the
container and add dishwasher salt.