Summit DW2432SS User Manual - Manual (Page 25)

23
Possible Causes:
• Insufficient rinse aid supply
• The hardness is not selected properly;
too little salt is being used.
• Salt loss (models with salt container)
Possible causes:
• Smell of new machine
• Filters are dirty.
• Dirty dishes standing in the machine
for a few days without being washed
• Dirty door gasket
Calcium streaks, misty appearance
Suggestions on how to fix this problem:
• Increase the dosage amount of rinse aid and/or refill
the rinse aid dispenser.
• Call water supplier and ask for local hardness in
grains per gallon or ppm. Use a higher phosphate
content detergent for hard water.
• Check whether the lid of the salt container is firmly
closed. Use the funnel to pour in special salt. Begin
Rinse and Hold program right after filling with salt.
After the program is complete, check whether the lid
may have loosened.
Smell
Suggestions on how to fix this problem:
• The smell of a new machine disappears after a few
wash cycles with detergent.
• Clean all filters as described in this manual.
• Remove coarse dirt under running water and run
the Rinse and Hold program every 2 days without
detergent.
• Regularly clean the door gasket with a damp cloth
to remove food particles and other debris. Use a
gentle household cleaner for the outside and the
door seals, then rinse thoroughly.