Summit DW2432SS Installation Manual - Manual (Page 20)

Notice:
The installer is responsible for the
dishwasher installation. Incorrect installation
is not covered by the warranty.
8. INSTALLER CHECKLIST
Your installer must have completed and
checked the following:
 The dishwasher is square and level.
 The dishwasher is fastened securely to
the cabinetry.
 The dishwasher door opens and closes
freely. The dishwasher door must close
without hitting any cabinetry or counter
top.
 The inlet water supply is turned on and
checked for leaks.
 The drain hose has been connected and
checked for leaks. There must be no
kinks or obstructions in the drain hose.
 The drain hose must be installed with a
28” (710mm) high drain loop for drain
hook-ups without any air removed.
 If the dishwasher drain is hooked up to a
garbage disposal, the drain hopper plug
must be removed.
 The spray arms are free and rotate freely.
 The rinse cycle has been run.
 The water level will be below the filter
screen after the end of the wash program.
It is normal to find some water in the drain
filter area.
 Set the water softener to the correct water
hardness for your area. If the dishwasher
drain is connected to a garbage disposal,
make sure that the drain/hopper plug has
been removed.
9. FINAL INSTRUCTIONS
1. Press the On/Off button to turn the
dishwasher on.
2. Power indicator light comes on.
3. Use the Cycle Select button to choose a
washing program.
4. Start the program with the Start/Pause
button.
5. Run the dishwasher through one
complete cycle. When the progress
indicator light “End” lights up, the wash
cycle is completed. Use the On/Off button
to turn the dishwasher off.
Notice:
If the dishwasher does not operate properly,
refer to the self-help hints.
10. SELF-HELP HINTS:
The power indicator light doesn’t come on:
 Check to make sure the circuit breaker to
the dishwasher is in the On position.
 Check all the wire connections in the
junction box are tight and not loose.
No water is coming into the dishwasher:
 Check to make sure the hot water shut-off
is in the On position.
Water does not drain:
 Make sure drain hose is not kinked or
comes out of air gap next to the sink.
 Remove drain hose from disposal, making
sure plug is removed.
Notice:
 If your dishwasher is not operating
properly after following these steps:
Contact your dealer to schedule an
authorized service agent to inspect your
new dishwasher for any function-related
failure.
 The manufacturer warranty does not
cover installation or customer education
service visits.
You will find the model and serial number
information on the label located on the right-
hand side of the inner door of your
dishwasher, as shown above.
Notice:
Please make a copy of your invoice and
keep it with this manual. You will need it
when you call for service (1-800-932-4267).
18