BT FREELANCE XH 2100 User Manual

Page 13

BT Freelance XH 2100 user guide ~ 2nd Edition ~ 18th March ’04 ~ 6012

Before you use your BT Freelance
XH 2100 for the first time, it is important
to have the handset batteries fully
charged. The batteries need to charge
continuously

for at least 16 hours

to reach full charge.

Place the handset on the base. The
red charging light will come on. The
handset comes pre-registered to the
base station as HANDSET HS1. This
is shown on the display. The

icon

and the battery icon are shown on
the display. Once the handset is fully
charged, the display shows a full
battery symbol.

Charge the handset batteries
for at least 16 hours

Install the rechargeable
batteries in the handset

Battery low warning

If the handset battery symbol is empty
and flashing, and you hear a warning
beep every minute, you will need
to recharge your handset before you
can use it.

The handset uses two rechargeable
Nickel Metal Hydride (Ni-MH) AAA
batteries which are supplied. Take
care to insert the batteries as shown
and then fit the battery cover (the
battery cover may be found in the
packaging with the batteries).

SETTING

Please note that the red charging light
will remain on even when the batteries
are fully charged.

BATTERY LEVELS

WEAK

HALF-FULL

FULL

Note

The

symbol on your handset display

indicates when you are in range of
the base station. If the symbol flashes
and you hear a warning beep, you
are out of range and will need to move
closer to the base station.