Bosch AQUA STAR 2400E LP - Manual (Page 26)

6 720 608 263
26
Operation instructions
Setting the water temperature
The desired temperature of the hot water can be adjusted on the front control panel of the heater.
The 2400 E has an electronically controlled gas valve that modulates the burner input in response to both varying hot
water flow rates and/or changes in any incoming and outgoing water temperatures.
Note: selected temperature on heater’s display will blink until that temperature has been reached.
Fig. 31 Flow/temperature chart
Note: Low flowing fixtures are the leading cause of
temperature overshoot. To combat this symptom, clean
aerators and shower heads or replace with higher
flowing fixtures if necessary.