Snakebyte Wireless MotionXS Quick start - Manual (Page 3)

Quickstart Guide Wireless Motion XS
Installation
Connecting the Wireless Motion XS
• Equip your Wireless Motion XS with two AAA batteries and make sure you always replace both
batteries at the same time and do not mix different types of batteries
• Connect the Wireless Motion XS receiver with the Extension Connector Port on the Wii Controller
• Once console and Wii™ Remote are activated press the Sync button on the Wireless Motion XS to
establish a wireless connection between the Motion XS and the receiver. A proper connection is
indicated by simultaneously flashing LEDs on the receiver and the Wireless Motion XS.
Proper use of the Wireless Motion XS
The Wireless Motion XS can not be used on its own, without the Wii Remote or snakebyte Remote XS. It adds
another dimension to Wii gameplay, but only complements the main controller.
When using the motion sensing features of the Wii Remote and the Wireless Motion XS please make sure not to
move too excessively. Be sure not to hurt people and/or damage objects around you. Make sure not to lose the
Wii Controller and Wireless Motion XS while playing by always wearing the wrist strap and holding both items
tightly.
There is no need to deactivate your Wireless Motion XS by pressing the Sync button or removing the batteries
from the battery compartment. If the Motion XS is not used for some minutes it will automatically enter sleep
mode. You need to press the Sync button again to reactivate the Wireless Motion XS.
Consult your game’s manual to find out if the Wireless Motion XS needs to be used. Not all games require you
to use a Motion XS add-on.
For further information please refer to your Wii™ console’s manual.
Troubleshooting
If you encounter any problems using the snakebyte Wireless Motion XS please read this section carefully before
contacting our customer support or your dealer.
1. My Wireless Motion XS does not work correctly at all.
Turn off your Wii™ console and turn it on again immediately. Make sure your Wii Controller is synced to the
console and the Wireless Motion XS receiver is firmly attached to the Wii Controller’s Extension Port. Please
refer to the installation instructions above.
2. My game seems to receive input signals although I do not even touch the Wireless Motion
XS.