Battery low – Sensaphone Express II User Manual

Page 47

Chapter 5: Programming

Battery Low

1. Battery monitoring enable/disable—This
command enables or disables the battery low
detection. When enabled, Express II will monitor
battery condition and dial out if it becomes low.
When disabled, Express II will not dial out for a
battery low condition. The default is

disabled.

2. Alarm reset time—After battery low condition is
acknowledged, Express II stops the dial out sequence.
However, the low battery condition will continue
to exist until it is recharged. If the battery is not
recharged after a certain amount of time, Express II
can be programmed to restart the dial out sequence.
This is called the alarm reset time. This parameter
may be programmed from 0 seconds to 12 hours.

If the alarm reset time is programmed to 0 seconds,
the feature is disabled. Express II will not restart the
dial out regardless of how long the alarm exists.

3. Dial Out Selection—You may program Express
II to call a specific set of Phone Contacts for battery
low only. This is called the Dialout Selection. To
return to the default, all contacts, press “9” “9,” and
then press ENTER.

Chapter 5: Programming

3) Enter list of dial out selection.

Press individual position numbers.
(1–48)
Press Enter.

4) When all position numbers in list are

entered, press Enter again.

5) The default is all contacts.

Press “

9” “9” for the default.

BATTERY

1) Return to the Power menu. Press

2 for

Battery Parameters.
The Battery menu will then be displayed.

1-Battery monitor:

1) Press

1 for Battery monitor at the Battery

menu.

2) Press

1 to disable.

Press

2 to enable.

2-Alarm reset time:

1) Return to the Battery menu. Press

2 for

Alarm Reset Time.

2) Enter hours.

Enter minutes.
Enter seconds.

3-Dialout selection:

1) Press

3 for Dial Out Selection at the

Battery menu.

2) Enter the list of position numbers, (1-48),

for the phone contacts to be dialed
by Express II in the event of Battery
Failure.(Battery monitor must be
enabled.)