Sensaphone Express II - Manual (Page 36)

34
Sensaphone ® Express II User’s Manual
DIAL OUT [2]
The following parameters control how Express II
communicates when it dials out for an alarm.
1. Dialing Method—This parameter determines
whether Express II will dial out using tone or pulse
dialing. The programming choices for this parameter
are Pulse, Tone, or Automatic.
Automatic instructs Express II to determine whether
to dial out in tone or pulse automatically.
NOTE: You must have a dedicated phone line for
Express II to use the Automatic method. If you
have Express II installed on an office system
that requires dialing an access number to
reach an outside line, you MUST program this
parameter as Tone or Pulse.
The default setting is AUTOMATIC. The choices
under “Dialing Method” are:
1 = Pulse; 2 = Tone; 3 = Automatic.
2. Retries on Busy—This determines how may times
Express II will hang up and attempt to recall a phone
number when it detects a busy signal. This parameter
may be programmed from 0–15. The default is
0.
NOTE: Each retry applies toward the Maximum
number of calls.
3. Message Repeat—When Express II dials out and
the call has been answered, this parameter determine
s how many times the unit will recite the recorded
alarm message per call. This parameter may be
programmed from 0 to 10 repetitions. The default is
3.
4. Maximum Number of Calls—This parameter
determines the maximum number of calls
Express II will make if the unit does not receive
acknowledgment. The maximum calls may be
programmed from 0 to 65,535. The default is
100. If the Express II has only one phone number
programmed to dial out for a particular alarm, it
will limit the maximum calls to 15 regardless of the
Maximum number of calls programmed.
5. Call Delay Time—This parameter is the length
of time that Express II will wait after an alarm is
recognized before it starts the dial out sequence.
(Note: This is not the same as input recognition time.)
Sensaphone ® Express II User’s Manual
DIAL OUT PARAMETERS
1-Dialing Method:
1) Press PROGRAM.
2) Press DIAL-OUT.
DIAL-OUT menu will then appear on
local display.
3) Press 1 for Dialing Method.
Press 1 for Pulse.
Press 2 for Tone.
Press 3 for Automatic.
2-Retries on Busy:
Return to Dial-Out menu.
1) Press 2 for RETRIES ON BUSY.
2) Press the amount of retries desired
using the number keys. Press
ENTER.
3-Message Repeat:
Return to Dial-Out menu.
1) Press 3 for MESSAGE REPEAT.