Sensaphone WEB600 Upgrade instructions - Manual (Page 3)

WEB600 Firmware Revision History
3
• Corrected an issue on the web page with the white min/max bars not displaying correctly on the bar
gauge.
• Corrected an issue on the webpage with the Schedule pop-up on the Profile screen.
Version 1.52 (June 5, 2012)
• Fixed a web page issue when disabling a zone which caused the zone programming link to disappear
on the Zones page.
Version 1.51 (April 27, 2012)
• First release.
Original WEB600
Version 1.46 (June 22, 2011)
• Fixed programming Save/Load compatibility issue when loading programming from older firmware
versions.
• Increased the allowable time range for the Alarm Hold Time function.
• Added a Reboot button to the Admin screen to restart the device
• Changed the default Time Server to time.sensaphone.com
• This version requires the latest MIB file for SNMP access
•
WARNING: Installing this update will reset the unit to factory defaults.
Version 1.43 (January 21, 2011)
• Added the Alarm Hold Time function.
•
WARNING: Installing this update will reset the unit to factory defaults.
Version 1.41 (December 10, 2010)
• Added support for custom dry-contact descriptions depending on the position of the contact.
•
WARNING: Installing this update will reset the unit to factory defaults.
Version 1.40 (November 19, 2010)
• Added a “Message failed” event for cases where the email server could not be contacted.
• Fixed a problem where email messages would fail to be delivered on certain networks.
•
WARNING: Installing this update will reset the unit to factory defaults if the current firmware
version is v1.30 or less.
Version 1.39 (July 15, 2010)
• No functional change - maintenance update only
Version 1.38 (April 26, 2010)
• No functional change - maintenance update only
Version 1.37 (April 19, 2010)
• Changed the e-mail functionality such that messages are considered successfully sent once the
protocol says it is sent, even if the connection closes non-gracefully.
• WARNING: Installing this update will reset the unit to factory defaults if the current firmware
version is v1.30 or less.
Version 1.36 (February 2, 2010)
• Fixed an issue where the last character in an alarm message was cut-off.
• Fixed a network issue where the HTTP connection would sometimes freeze.