beautypg.com

Schwank SCH-90 Construction User Manual

Page 6

background image

GP-MCH9-BX-10C

SCH-90 / IC-90 Manual

R.D: Aug 2006

RL:10C

KH

Page 6

WARNING

DO NOT use heater in living or office areas.

Approved for heating buildings or structures
under construction, alteration or repair.

Use only in well ventilated areas.

Heater must be used exclusively for heating
purposes.

The distance between the heating surface top to
the nearest combustible must be at least 24
inches. The distance from the burner surface, in
a horizontal plane, to the nearest combustible
must be at least 48 inches.

The heater must not be directed towards any LP
gas container within 10 feet.

The fuel supply line must not be placed near the
burner heat zone.

DO NOT store or use gasoline or other
flammable vapors or liquids in the vicinity of this
or any other appliance.

DO NOT use this heater if any part has been
under water. Call a professional gas appliance
service person to inspect the heater, and to
replace any part which has been under water.

Any changes to this heater or the heater’s
controls can be very dangerous.

Any part removed must be replaced prior to
operating the heater.

Failure to follow these warnings may result in
property damage, bodily injury or death.

The heater must be installed in such a way that it
is not directly exposed to water spray, rain and or
dripping water.

HEATER

MUST BE

LEVEL

BEFORE

OPERATING

NOT FOR HOME OR

RECREATIONAL VEHICLE USE



This heater is designed and approved for use as
a construction heater per Canadian Standard
2.14 and Ansi Z83.7 –2000.
CHECK WITH YOUR LOCAL FIRE SAFETY
AUTHORITY IF YOU HAVE ANY QUESTIONS
ABOUT APPLICATIONS
. Other standards

govern the use of fuel gases and heat producing
products in specific applications. Your local
authority can advise you about these.

WARNING

WARNING

1.0 INSTALLATION REQUIREMENTS


1.1 GENERAL INSTRUCTIONS


1. Examine contents for damage or missing parts before proceeding with these instructions.

2. Installation of heaters must conform to all local codes.

3. Ensure that heater is level before operation.